A large chemical processor called BETE in need of a special XA lance to inject toluene into a process stream. The customer had an existing 36" duct with a 4" pipe entering it at a 45 degree angle. The BETE XA lance would need to enter through the 4" pipe yet spray parallel with the 36" duct.
BETE Applications Engineers designed a special BETE XA body that would spray in a direction 45 degrees offset from the inlet pipes. This would allow the specified XAPR250 setup to spray co-currently with the process gas flowing through the duct. The body was incorporated into a lance assembly, also designed by BETE, providing a convenient solution for the customer.
To discuss your fluid-related challenge, please contact BETE Applications Engineering at 413-772-0846 or firstname.lastname@example.org.